Release Notes Lab App

Connect sensor page
- Already connected sensors can be connected again without internet connection
- Already connected sensors are displayed with device model and size (e.g. “°Two (S)”)
- New icon where to find the serial number

Dashboard
- The device model shows °Two instead of two
- Battery percentage shown
- Sensor errors and error codes are displayed on the dashboard if the sensor has any issues.
New side menu style with link to public Wiki lab app page
Device Firmware Update (DFU)
- DFU starts only with > 30% battery
- More information before starting DFU
- BLE pairing within LabApp
- More prominent hint when DFU is ongoing
- Progress indicator shows progress and current status
- Error dialogs popping up if something goes wrong

A bond between phone and sensor cannot be removed from within the app. To do this, use Android Bluetooth settings to remove the bond.
Sometimes after the DFU, the app thinks that the sensor is still in Bootloader mode (“updating mode”, “DfuTarg”) but the sensor acutally is updated and fully operational. This is an Android Bluetooth caching issue. It may help to close the app, turn off and on Bluetooth and start the app again.